The gangue crusher is a high-efficiency and energy-saving crusher with leading technology and relatively affordable price in the current series of crusher equipment. During the production process, strict quality control must be passed. The continuous technological improvement and innovation of the gangue crusher make the produced The coal gangue crusher is more durable, the fineness of the coal gangue crusher with good performance is low, the use noise is small, the energy saving is convenient and fast, and one set of coal gangue crusher is equivalent to two sets of old-fashioned coal gangue crushers before and can be used The cost is greatly reduced, and the crushing effect of "hard material", "dry material" and "wet material with high water content" is very good, there is no clogging during use, the water content of the feed material can reach the water content without requirement, and the output material is fine The degree is about 90%

Possessed performance and features:

1. The upper and lower stages of crushing, the two sets of rotors connected in series, make the material crushed by the hammer head of the upper stage rotor immediately be finely crushed again by the hammer head of the rapidly rotating lower stage rotor, and the materials in the inner cavity collide with each other rapidly and crush each other , to achieve the best crushing effect.
2. Unique two-way gap adjustment technology, after the hammer head is worn out, the gap between the liner and the liner becomes larger and the particle size becomes thicker. The position of the hammer head can be moved outward from the center to narrow the gap between the liner and the liner to continue to use, and the liner can also be pushed from the outside to the inside. The plate adjusts the gap and controls the output particle size by itself.
3. The design of this machine has no sieve grate bottom, no strict requirements on the moisture content of the material, there is no problem of paste blocking the sieve plate at all, and there is no problem that the fine powder cannot be discharged in time and repeated crushing, the powder output efficiency is high, and there is no problem Ineffective wear of the hammer head.
4. The operation is stable and the inertia is large. The upper and lower sets of rotor shaft ends are equipped with flywheels. The flywheels can adjust the periodic speed fluctuations of the operation to make it run evenly and smoothly, increase the rotational inertia, overcome the movement resistance, and save more than 20% of electricity.
5. Centralized lubricating system, non-stop oiling, reforming the grease nipple, oil cup traditional way of filling lubricating oil, equipped with centralized oil supply distribution pump, one-step operation, multi-channel oil supply, the whole machine can be all at any time under the working state of the machine The bearings are simultaneously filled with lubricating oil, which is convenient and quick.